0
ACTIVE
Bits (#) |
4 |
Data rate (max) (Mbps) |
24 |
Topology |
Open drain, Push-Pull |
Direction control (typ) |
Auto-direction |
Vin (min) (V) |
1.65 |
Vin (max) (V) |
3.6 |
Vout (min) (V) |
2.3 |
Vout (max) (V) |
5.5 |
Applications |
GPIO, I2C, JTAG, MDIO, SDIO, SMBus, SPI, UART |
Features |
Edge rate accelerator, Output enable |
Prop delay (ns) |
120 |
Technology family |
TXS |
Supply current (max) (mA) |
0.025 |
Rating |
Automotive |
Operating temperature range (°C) |
-40 to 125 |
TSSOP (PW)-14-32 mm² 5 x 6.4
Qualified for automotive applications
AEC-Q100 qualified with the following results:
Device temperature grade 1: 40°C to +125°C ambient operating temperature range
Device HBM ESD Classification Level 2
Device CDM ESD Classification Level C6
This 4-bit non-inverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.65V to 3.6V. VCCA must be less than or equal to VCCB. The B port is designed to track VCCB. VCCB accepts any supply voltage from 2.3V to 5.5V. This allows for low-voltage bidirectional translation between any of the 1.8V, 2.5V, 3.3V, and 5V voltage nodes.
When the output-enable (OE) input is low, all outputs are placed in the high-impedance state.
The TXS0104V-Q1 is designed so that the OE input circuit is supplied by VCCA.
For the high-impedance state during power up or power down, tie OE to GND through a pull-down resistor; the current-sourcing capability of the driver determines the minimum value of the resistor.
WELL LINK CHIPS GROUP CO.,LIMITED FLAT/RM 1802 BEVERLY HOUSE 93-107 LOCKHART ROAD WANCHAI HK
