0
TPS7H2140-SEP
  • TPS7H2140-SEP
  • TPS7H2140-SEP
  • TPS7H2140-SEP

TPS7H2140-SEP

ACTIVE

Radiation-tolerant, 4.5-V to 32-V, input 1.35-A 160-mΩ quad-channel eFuse

Texas Instruments TPS7H2140-SEP Product Info

1 April 2026 7

Parameters

Vin (max) (V)

32

Vin (min) (V)

4.5

Current limit (max) (A)

7

Current limit (min) (A)

0.25

Features

Current monitoring, Thermal shutdown, Under voltage lock out

Overcurrent response

Circuit breaker, Current limiting

Fault response

Auto-retry

Ron (typ) (mΩ)

160

Rating

Space

Soft start

Fixed

Quiescent current (Iq) (typ) (A)

0.0062

Quiescent current (Iq) (max) (A)

0.0062

Device type

eFuses and hot swap controllers

Operating temperature range (°C)

-55 to 125

Package

HTSSOP (PWP)-28-62.08 mm² 9.7 x 6.4

Features

  • Vendor item drawing available, VID V62/23610
  • Total ionizing dose (TID) characterized to 30 krad(Si)
    • RLAT (radiation lot acceptance testing) to 20 krad(Si)
  • Single-event effects (SEE) characterized
    • Single-event latch-up (SEL), single-event burnout (SEB), and single-event gate rupture (SEGR) immune to linear energy transfer (LET) of 43 MeV-cm 2/mg
    • Single-event transient (SET) and single-event functional interrupt (SEFI) characterized to effective linear energy transfer (LET) of 43 MeV-cm 2/mg
  • Quad-channel 160-mΩ eFuse with full diagnostics and current-sense analog output
  • Wide operating voltage 4.5 V to 32 V
  • Ultra-low standby current < 500 nA
  • High-accuracy current sense: ±15% when I LOAD ≥ 25 mA
  • Adjustable current limit with external resistor (R CL), with accuracy of ±15% when I LOAD ≥ 500 mA
  • Protection
    • Short-to-GND protection by current limit (internal or external)
    • Thermal shutdown with latch off option and thermal swing
    • Inductive load negative voltage clamp with optimized slew rate
    • Loss-of-GND and loss-of-power protection
  • Diagnostics
    • Overcurrent and short-to-ground detection
    • Open-load and short-to-power detection
    • Global fault report for fast interrupt
  • 28-pin thermally-enhanced PWP package
  • Space Enhanced Plastic (SEP)
  • Available in military (–55°C to 125°C) temp range
  • Vendor item drawing available, VID V62/23610
  • Total ionizing dose (TID) characterized to 30 krad(Si)
    • RLAT (radiation lot acceptance testing) to 20 krad(Si)
  • Single-event effects (SEE) characterized
    • Single-event latch-up (SEL), single-event burnout (SEB), and single-event gate rupture (SEGR) immune to linear energy transfer (LET) of 43 MeV-cm 2/mg
    • Single-event transient (SET) and single-event functional interrupt (SEFI) characterized to effective linear energy transfer (LET) of 43 MeV-cm 2/mg
  • Quad-channel 160-mΩ eFuse with full diagnostics and current-sense analog output
  • Wide operating voltage 4.5 V to 32 V
  • Ultra-low standby current < 500 nA
  • High-accuracy current sense: ±15% when I LOAD ≥ 25 mA
  • Adjustable current limit with external resistor (R CL), with accuracy of ±15% when I LOAD ≥ 500 mA
  • Protection
    • Short-to-GND protection by current limit (internal or external)
    • Thermal shutdown with latch off option and thermal swing
    • Inductive load negative voltage clamp with optimized slew rate
    • Loss-of-GND and loss-of-power protection
  • Diagnostics
    • Overcurrent and short-to-ground detection
    • Open-load and short-to-power detection
    • Global fault report for fast interrupt
  • 28-pin thermally-enhanced PWP package
  • Space Enhanced Plastic (SEP)
  • Available in military (–55°C to 125°C) temp range

Description

The TPS7H2140-SEP device is a fully protected quad-channel eFuse with four integrated 160-mΩ NMOS power FETs.

Full diagnostics and high-accuracy current sense enables intelligent control of the loads.

An external adjustable current limit improves the reliability of whole system by limiting the inrush or overload current.

Subscribe to Welllinkchips !
Your Name
* Email
Submit a request