0
TPS650002-Q1
  • TPS650002-Q1
  • TPS650002-Q1

TPS650002-Q1

ACTIVE

2.25MHz step-down converter with dual LDOs and SVS Power Management IC (PMIC)

Texas Instruments TPS650002-Q1 Product Info

1 April 2026 6

Parameters

Product type

Camera sensor

Regulated outputs (#)

3

Step-down DC/DC converter

1

LDO

2

Vin (min) (V)

2.3

Vin (max) (V)

6

Vout (min) (V)

1.2

Vout (max) (V)

2.8

Iout (max) (A)

0.6

Configurability

Factory programmable

Features

Enable pin, Power good, Spread-Spectrum Clock (SSC) Generation

Rating

Automotive

Operating temperature range (°C)

-40 to 105

Step-up DC/DC controller

0

Iq (typ) (mA)

0.073

Switching frequency (max) (kHz)

2410

Shutdown current (ISD) (typ) (µA)

0.16

Switching frequency (typ) (kHz)

2250

Package

WQFN (RTE)-16-9 mm² 3 x 3

Features

  • Qualified for automotive applications
  • AEC-Q100 qualified with the following results:
    • Device temperature grade 2: –40°C to +105°C, TA
  • Step-down converters:
    • VIN range from 2.3 V to 6 V
    • 2.25-MHz Fixed-frequency operation
    • 600-mA Output current
  • LDOs:
    • VIN Range From 1.6 V to 6 V
    • Up to 300-mA output current
    • Separate power inputs and enables
  • 3-mm × 3-mm 16-Pin WQFN
  • Qualified for automotive applications
  • AEC-Q100 qualified with the following results:
    • Device temperature grade 2: –40°C to +105°C, TA
  • Step-down converters:
    • VIN range from 2.3 V to 6 V
    • 2.25-MHz Fixed-frequency operation
    • 600-mA Output current
  • LDOs:
    • VIN Range From 1.6 V to 6 V
    • Up to 300-mA output current
    • Separate power inputs and enables
  • 3-mm × 3-mm 16-Pin WQFN

Description

The TPS650002-Q1 device is a single-chip power-management IC (PMIC) for automotive applications. This device combines a single step-down converter with two low-dropout regulators. The step-down converter enters a low-power mode at light load for maximum efficiency across the widest possible range of load currents. For low-noise applications, the device can be forced into fixed-frequency PWM using the MODE pin. The step-down converter allows the use of a small inductor and capacitors to achieve a small solution size. A power-good status output can be used for sequencing. The LDOs can supply 300 mA, and can operate with an input voltage range from 1.6 V to 6 V, thus allowing them to be supplied from the step-down converter. The step-down converter and the LDOs have separate voltage inputs and enables, thus allowing for design and sequencing flexibility.

The TPS650002-Q1 device is available in a 16-pin leadless package (3-mm × 3-mm WQFN).

Subscribe to Welllinkchips !
Your Name
* Email
Submit a request