0
SN74CBTLV3857
  • SN74CBTLV3857

SN74CBTLV3857

ACTIVE

3.3-V, 1:1 (SPST), 10-channel FET bus switch with internal pulldown resistors

Texas Instruments SN74CBTLV3857 Product Info

1 April 2026 4

Parameters

Protocols

Analog

Configuration

1:1 SPST

Number of channels

10

Bandwidth (MHz)

200

Supply voltage (max) (V)

3.6

Ron (typ) (mΩ)

5000

Input/output voltage (min) (V)

0

Input/output voltage (max) (V)

3.6

Operating temperature range (°C)

-40 to 85

Input/output continuous current (max) (mA)

48

COFF (typ) (pF)

5

OFF-state leakage current (max) (µA)

1000

Ron (max) (mΩ)

40000

VIH (min) (V)

Vref+180mV

VIL (max) (V)

Vref-180mV

Rating

Catalog

Package

SOIC (DW)-24-159.65 mm² 15.5 x 10.3

Features

  • Enable Signal Is SSTL_2 Compatible
  • Flow-Through Architecture Optimizes PCB Layout
  • Designed for Use With 200 Mbit/s Double Data-Rate (DDR) SDRAM Applications
  • Switch On-State Resistance Is Designed to Eliminate Series Resistor to DDR SDRAM
  • Internal 10-k Pulldown Resistors to Ground on B Port
  • Internal 50-k Pullup Resistor on Output-Enable Input
  • Rail-to-Rail Switching on Data I/O Ports
  • Ioff Supports Partial-Power-Down Mode Operation
  • Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
  • Enable Signal Is SSTL_2 Compatible
  • Flow-Through Architecture Optimizes PCB Layout
  • Designed for Use With 200 Mbit/s Double Data-Rate (DDR) SDRAM Applications
  • Switch On-State Resistance Is Designed to Eliminate Series Resistor to DDR SDRAM
  • Internal 10-k Pulldown Resistors to Ground on B Port
  • Internal 50-k Pullup Resistor on Output-Enable Input
  • Rail-to-Rail Switching on Data I/O Ports
  • Ioff Supports Partial-Power-Down Mode Operation
  • Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

Description

This 10-bit FET bus switch is designed for 3-V to 3.6-V VCC operation and SSTL_2 output-enable (OE) input levels.

When OE is low, the 10-bit bus switch is on, and port A is connected to port B. When OE is high, the switch is open, and the high-impedance state exists between the two ports. There are 10-k pulldown resistors to ground on the B port.

The FET switch on-state resistance is designed to replace the series terminating resistor in the SSTL_2 data path.

This device is fully specified for partial-power-down applications using Ioff. The Ioff feature ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off.

Subscribe to Welllinkchips !
Your Name
* Email
Submit a request