Type	Single Channel
Inputs	1 XTAL/SE, 3 D/SE
CMOS Outputs	6
Low-Jitter Synthesizers	1
Typical Jitter (12kHz-20MHz) fs RMS	160
Diff InputFreq. Range	1 kHz–1250 M
Output Freq Range	<1 Hz–1035 M

Three Input Clocks
• Two Differential/CMOS inputs
• One single-ended/CMOS input
• Any input frequency from 1kHz to 1250MHz (1kHz to 300MHz for CMOS)
• Inputs continually monitored for activity and frequency accuracy
• Automatic or manual reference switching

Low-Bandwidth DPLL
• Programmable bandwidth, 14Hz to 500Hz
• Attenuates jitter up to several UI
• Freerun or digital hold on loss of all inputs
• Digitally controlled phase adjust

Low-Jitter Fractional-N APLL and 3 Outputs
• Any Output Frequency from <1Hz to 1035MHz
• High-resolution fractional frequency conversion with 0ppm error
• Easy-to-configure, encapsulated design requires no external VCXO or loop filter components
• Each output has independent dividers
• Output Jitter Typically 0.16 to 0.28ps RMS (12kHz to 20MHz integration band)
• Outputs are CML or 2xCMOS, can interface to LVDS, LVPECL, HSTL, SSTL and HCSL
• In 2xCMOS mode, the P and N pins can be different frequencies (e.g. 125MHz and 25MHz)
• Per-output supply pin with CMOS output voltages from 1.5V to 3.3V
• Precise output alignment circuitry and per-output phase adjustment
• Per-output enable/disable and glitchless start/stop (stop high or low)

General Features
• Automatic self-configuration at power-up from internal EEPROM; up to four configurations, pin-selectable
• Numerically controlled oscillator mode
• Spread-spectrum modulation mode
• SPI or I2C processor Interface
• Tiny 5x5mm QFN package
• Easy-to-use evaluation software
• ZL30253 can be ordered with up to four user-defined, factory-programmed device configurations

CREATE AND SAMPLE YOUR CUSTOM ZL30253 HERE

The ZL30253 is a flexible, high-performance, clock multiplier/jitter attenuator IC. From any input clock frequency 1kHz to 1250MHz the ZL30252 can produce frequency-locked output frequencies from 1Hz to 1035MHz and as many as 3 differential or 6 CMOS output clock signals. Output jitter is typically 0.16 to 0.28ps RMS (12kHz to 20MHz). Automatic self-configuration from internal EEPROM allows clock signals to be available immediately after power-up or reset.