Conforms to ISO11898-1:2015
• Supports both CAN 2.0B and CAN FD
• Arbitration Bit Rate up to 1 Mbps
• Data Bit Rate up to 8 Mbps
• Up to 20MHz SPI Clock Speed

Flexible FIFO setup
• 31 FIFOs configurable as transmit or receive
• 32 Flexible Filter and Mask Objects
• One Transmit Queue

Misc
• 32-bit Time Stamp
• Bus Health Diagnostics and Error Counters
• Packages: VDFN14 (Wettable Flanks), SOIC14
• Temperature Range: -40°C to +150°C

Low power consumption
• VDD: 2.7V-5.5V
• Active Current Max: 12mA @ 5.5V, 40 MHz CAN Clock
• Sleep Current: 10uA, Typical

Built-In Safety features
• Loopback mode
• SPI commands with CRC to detect noise on SPI interface
• ECC for the SRAM 1 bit correction, 2 bit detection

The MCP2517FD is a cost-effective and small-footprint External CAN FD Controller that can be easily added to a microcontroller with an available SPI interface. Therefore, a CAN FD channel can be easily added to a microcontroller that is either lacking a CAN FD peripheral or that doesn't have enough CAN FD channels.

The MCP2517FD supports both CAN frames in the Classical format (CAN 2.0B) and CAN Flexible Data Rate (CAN FD) format as specified in ISO11898-1:2015.

Please see our MikroElektronika click Board! https://shop.mikroe.com/mcp2517fd-click

Not recommended for new designs. Consider using the pin- and functionally compatible MCP2518FD

An MCAL driver is available upon request as described here: https://www.microchip.com/en-us/solutions/automotive-and-transportation/software

Please contact your local Sales representative.

The MCP2518FD is supported in the mainline linux kernel since Kernel version 5.10 and can be found here

Backports and an external kernel module can be found here